It establishes the true length of the pipe from the upper plane to lower plane across the box. Notice the dimension labeled TRAVEL in Figure 13-25. Rolling offsets are typically fabricated using 45° elbows therefore, the vertical angle will be 45°. The RISE is determined by subtracting the lower plane elevation from the upper plane elevation. Notice the SA of triangle 3 in Figure 13-28 is equal to the RUN of the box, the ROLL of the box is equal to the SO of triangle 3, and angle X of triangle 3 is the same as the horizontal angle (HOR°). When a rolling offset is part of a configuration similar to that shown in Figure 13-28, the lengths of the sides of triangle 3 are applied to the dimensions of the isometric box (see Figure 13-25). There are four length dimensions and two angular dimensions. Figure 13-25 identifies the six measurements required to dimension a rolling offset.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |